General

Just a question about where can I get hold of some 3/4 inch black iron pipe, the sort that used to be used for gas or water pipe. I need to support the FJR when I remove the centre stand and the rear swing arm, this years little job ! But I'm buggered if I can find anywhere that sells the stuff in the lengths that I want and with the threads cut into it. Any of you that can help out with a suggestion I will be really grateful. Thanks peeps.

Hi I have a error code 19 (no signal from ignition to ecu) on dashboard. I have replaced the ignition switch as old one was faulty. Previous to this I had a error code of 46(power supply to FI system) which I had to change - Blocked fuel injector ECU unit Stator Magneto (burnt) Replaced Battery as old one was not holding charge Checked black/white wire traced from ignition to ecu which is fine on continunity I have no spark so waiting for a replacement ht coil to see if this is the problem. I have changed the ht coil still not working. Can anybody let me know if could be wiring loom a break somewhere?

Hi! I have recently bought an Rs125dx 1979 model to restore! I’m a bit short on a few bits and am finding them tricky to get hold of! If anyone has got any ideas or pointers, or anything hidden in the back of their shed I would be very grateful! Bits I’m short of include but are not limited too! Exhaust down pipe. carbuerettor insides (spring needle etc) seat any other spares or bits for sale would also be greatly appreciated! Many thanks Peter

Hello Folks, I am new and I do not have enough experience with bikes, especially the new one, I just bought my YBR 125, I am curious if someone of you can guide me about the following 1- What is the maximum running speed for a new bike? 2- What is the mileage for a new bike to complete running? Thank you! Javed

Hello Yamaha owners. My 1994 Yamaha Sr125 workhorse finally gave up on me last week. There’s still combustion and the clutch is fine but the transmission/gear-set is buggered. I’m going to swap engines. Will a ‘96 engine, for example, fit my ‘94?? Is there a way using websites, registrations or serial numbers that I can use to cross reference engines with chassis’ to confirm compatibility?

Hi I’ve recently bought a Yamaha it 400 c and I’m trying to register it on the the road but I’m missing a dating certificate can anyone help me please ? Thanks gary

Hi all, New to the site, im struggling to find a decent waterproof phone mount for a samsung s9plus. I have seen a pic of a break reservoir mount but for the life of me cant find one. Thank you

Hi guys does any one no if i coud change my elictronic speedo to cable drive this is a Yamaha FZS 600/1999 would be creatfull for any info Alvin

Yep, sold the cruiser a couple of weeks ago. Didnt need to sell, but 1500 miles in the last 3 years on it, seemed a shame for it just to sit in the garage. No regrets, gonna spend a bit on the Fazer now, powercommander to be fitted, likely to need new tyres this winter along with chain and rear sprocket. Going to have a look at a rear view camera set up too, so may be able to dump the mirrors

Hey all - long time no speak, I hope everyone is well? ? Sorry I've not been around for a long time - I'm sure I've missed out on some meets. I am still riding though and even went over to France on the bike this year - my first time. Anyway, I'm not sure who of the regulars still frequent this joint...

Hi can anyone give me some advice on getting my dt175 a darting sertificat it’s not registered so i need to get it on the nova dater base so I can register it? any advice would be appreciated. Cheers

Anyone happen to have a wiring diagram for the sachs roadster 125 v2 Thanks

Hi I'm new to this site. I've just acquired a tzr50 as a project to restore Any ideas where I can get hold of some new fairings as there missing? Any help welcome

Hi there I’m looking to get a better top speed on my 2008 Yamaha yzf r125 it’s got a couple of bits done to it like straight pipe sports exhaust upgrade brakes but wanna get the most out of my engine it’s got a rev limiter at 10k revs and just want to fully derestrict it

Hello to all ,#######....... Selling is only allowed in the for sale area. (Mod edit, cynic)

The rubber strip that runs round the base of my helmet has unstuck itself with the heat and my head drenched in sweat. Is there a safe glue you guys can recommend?

Hi my name is Harvey, i am currently restoring a 1987 DT50MX to as close as factory as possible in time for my 16th to ride. while doing this it needs a respray of the tank and plastics, I was wondering what the original blue colour is called. I have herd that "Peacock Blue" is close but after looking at other peoples blue DT50MX's they all seem to be a different colour so if anyone knows please help me with this your help will be much appreciated. Thanks Harvey

I haven't posted on this forum outwith the welcome page yet so wasn't sure where to put this. Went for general so i didnt clog up the events page (will put something there later if it is more relevant). The yorkhill easter egg run is something I've always enjoyed seeing from an outside perspective and now I've got 2 wheels it's something I'd possibly like to get involved in. Really just wanting to see if its a thing that many people on here do or have done in the past? Its on the 1st of april this year, It is a day I'm working but i was looking at getting the day off or maybe seeing if my work would support it as they do alot of local charity work. If a…

Hi guys! Can anyone confirm whether this is actually the 2018 model? (LINK) My friend says its not but the sales representative claims that it is. I've been burned before and I want to take all precautions before going any further with this dealer. Thanks and happy riding!

Hi all, the desperately needed website change is a work in progress, please let me know if you see any issues. Cheers Alex