The Bar

I need some help finding a decent place to order parts from, any suggestions??

Hello dare , Anybody know of direct replacement for the fuel pump on a 1994 exup 1000 . I think a thundercat one will fit . any help on this would be greatly appreciated , because as we all know genuine yam parts cost the earth . Cheers

I am the proud owner of a 77 dt250. Ground up. All seals replaced in the engine. Wiesco 1mm over piston and rings. Boyensen reed valves. New points and condensor. Spent countless hours getting the timing right. It has a horrible mid range miss. Plug is dark black carbon. Stock jetting in carb. Float is set correctly. Starts like a champ first kick. Excellent compression. Dialed the injection pump back a little from factory recommended. Using Mobil 1 synthetic 2 cycle. Any thoughts? Some smoking at idle. Not a fogging but noticeable. Just sputters at a steady throttle.

HI, i am looking for a windsheild for a dragstar 650 can anyone help

Hi all, many moons ago i cut my teeth on an 88 genisis thou, it has always had a special place in my bike memories, and last week the gods of two wheels saw fit to put a 1990 fzr 1000 in my path for the sum of 300 sheets. I kind of knew we were destined to spend a long time in the shed together from the phone call, but she's now in my van,in more pieces than i can count along with a new akropovic race can as the pipes are more than a little shagged. I work away from home most of the time so this is going to be a long rebuild it's gonna need a lot of time and lovin to get this bike back to the brute it once was but i'm meticulous and determined and can't wait to start.the …

Hi can anyone help me. I have just got a Yamaha RD200 and it needs a full restore as its been sitting for years. Battery is totally dead and i cant get a spark. Has anyone got any ideas where to start? cheers Paul

hi i want to change the oil in my tdr 125 its 2003 model ive bought 1ltr of putoline se 80w90heavy gearbox oil ... and 1ltr of putoline ttx 100% synthetic 2 stroke oil for injector and pre mix both wer recomended in bikeworld store 1st are they right for the bike ?? 2nd what oil goes were and how much do i use ? id take it do a shop and get it serviced but really want to get to no the bike and do the job myself i also got sum halfords coolant 50/50 mix wud that do ? any advice would b great thanks

I've been so busy this season that I've got too many great photos to choose from for my calendar. Please can you help by voting on the ones you like best, don't just pick the Yamahas! Voting Album If you would like to make a calendar request, add/update your details you can click here: address form In this time of the 'credit crunch' if you can offer something towards production and p&p then you can always click here: Donate For those who've never seen one of my desk calendars, here's a sample shot of the current edition, sits neatly in a cd sized display case: Cheers, Bloke.

I'm new to motorised 2 wheels and have recently acquired a YBR 125 custom to practice on before I go for Direct Access. The only thing that bugs me is the poor rear vision from my miirrors. Now you may say that its because the YBR is naff or its because I'm not used to cycle mirrors but I dont think the view is good at all. I can see well to the rear left and rear right but if the mirrors were a little longer I'm sure the rear view would be better. Is there anything I can do to improve this? thanks

Hi Guys, I'm new here. Just wondering if someone can help me out, I have a 2011 Yamaha XT 125 X & have a problem with it, When the engine is warm & you leave it for say 10 seconds, then give it a little blip on the throttle, the revs suddenly drop & sometimes it even cuts out, When I bought it new, It was running very weak, So I richened it up & seems to run smoother, But have had this problem with it since new. I have only done 700 miles on it, I have turned the mixture screw again even further out, But still seems weak, The screw is now fully turned out, I'm thinking it needs a bigger pilot jet in, (As it is a tickover/bottom end related issu…

Hi I am a new here and a new rider and a new yamaha owner. I just bought my first bike couple of days ago and while I waited for the insurance documents to arrive, I noticed that the tyre pressure in the rear tyre has gone down. The tyre is not flat, but it isn't inflated as the front tyre either? I don't have an air pump. What should I do? - walk the bike to the petrol station 0.4 miles away to check if it's a puncture or just the air leaked out. If so, how and where should I walk the bike? sidewalk or on-road? Do I need to be wearing a helmet while walking the bike? - since I haven't got the insurance documents yet, I don't have a 'breakdown cover' …

Could this be it Steve? http://www.ebay.co.u...=item20bc29e356 Newbury_Frome ...geographically possible

any idea wat i could use to clean my exhaust on my tdr to bring it back to new

got a xj650 maxim having an issue with it stalling while riding . can start it back up with elec start but after a ride i park it for a day or two and then i loose spark . had it at triple m motorsports in edmonton they had it for a month and a half and 1600$ later and no fix , anyone have any insight to a fix please let me know

mate at work came in this morning , smile from ear to ear.just passed his bike test while i had a week off . i was wondering who's the bandit was in the car park. well done i said , but are you allowed one o them, oh, yer cos i took mi test on a 600cc and got me direct exess or whatever,cor fuckin hay ,say's me. now just one question , why the fuck have you parked it in my parking bay. oh ,erm , so you'd see it when you arrived , i couldn't bloody miss it , it's bright yellow, Then came the stupid challange ,do you wanna race say's he, yes says me , where to say's he , my house say's me. now bearing in mind my rd is in the garage, so im on the yamaha passola…

Hey folks. I’m just getting myself back into biking and have bought a DT125R (2001) to start off. The bike has been stripped of all road parts for full time off road use. When I bought it I was told the power valve does not open/close, and has been set mid way. Apparently this is because some part of the electrics &/or the battery has been removed (there is no battery). When I first got the bike this was fine, but now I would like more low/high range power to do jumps etc. Can anyone help me restore the power valve to open and close automatically as it should? Any help/advice appreciated

iv noticed my yamaha tdr has no petrol light how wud i no if in gna run out ?

Hi, I have a DT 175 MX I have re built from a rust bucket but have no paperwork for it and want to ride it on the road, not evn sure what year it is?

Hey all, im buying a set of downhill handlebars and a stem off adrenaline-pedstop tomorrow, jus wanted to know if i buy them both, can i just fit the old fitments eg-throttle and brake set up back on the new bars as normal ? Appreciated much