The Bar

Hi Guys, is it possible to adjust the cam chain on a XT350? Minds rattling a bit when rolling off the throttle.

Does anyone know what hand graurds will fit TDM 900A on a 07 plate

hi folks the front forks of my fazer are all pitted is there any way to clean them up? it is not the shock bit but the laquered bottom bit,ie the thick bit of the shocks. the neglect was not caused by me but the person who owned it before. i am doing this as a project/learning about bikes while i sit my das course and hopefully it will be fit and ready to go as soon as i pass. cheers for all your help and advice friedegg

hi there does any body know a good place to get cheap brake calipers for my fzs 600 x plate. the ones on it have seized as the numpty i bought it from didnt look after it.they have been stripped down but but one piston on the rear wont budge so before even looking at the front ones i have resigned myself to needing to buy all three. mail order/web sites any help. cheers in advance for any info thanks friedegg

Evening all, Just a quick question for all you DT fans ! I'd like to know what you think of doing a steady 60mph for about an hour or so on a dt125 (my lil bike) Do you think i will be killing my lil engine ? I'd like to think not but im not sure ! What ya think.

hi all dose anyone know if yzf r250 a4 is real or not

hi everyone having some problems with my bike and was wondering if anyone had any idea what i could be. i went to my local bike meet in pool dorset on tuesday and the bike seemed fine on the way up maybe a little slugish at times but made it there ok then on the way home it was fine until i went 2 stop at some traffic lights i went through the gears as normal but when i was stopping the bike didnt seem 2 want to slow down so i put it in neutral and the revs where at 4 and a half k its never done this before and was wondering if anyone had any ideas what it might be. i used the bike today for about an hour and it seemed fine no fast ideling any help would be appreciated t…

hi all ,this is my 1st postand my question may have been asked b4,but here goes.Ive bought a tdm850 4tx,the bike had been neglected and needed a new tank and a few other bits and bobs.My question is there seems to be a pipe that comes off between the two carbs and doesnt go anywhere ,i thought it mite be a fuel line,but on the tap the pipe is bigger and seems to go to the pump.Is it a vacum?there is also a long pipe with what looks like a filter in the middle of it .where does this go.there is a off take on the air box and also one under the tank?.Any help wld be grt.

HI CAN ANYONE SURJEST WHERE I MIGHT BE ABLE TO OPTAIN F/R WHEEEELRIMS FOR MY 1977 DT400 B THANKS?

Does anyone have any knowledge on the sports screens you can get off the yamaha website for the 125 range of bikes??

hi guys having got my mk2 dt125lc i started searching the net for parts and spares i conme across 2 more dts but these are the mk1 10v i was just wondering how much would a bottom end rebuild cost as one of the mk1 s seems to be a bit rough cheers

Hi guys, Im after some advice please. Had a service done last week on my fazer 600s, nearly two years old and already up to 9500 miles on it....wooo hooo. Anyway, was told that i would need a new rear tyre soon, about a thousand miles left on it, even though there`s loads of `meat` on it, the middle is starting to wear thin apparentley, so, my question, whats the average millage on tyres anyway? Also, do i have to have the front one changed at the same time, even if there is nothing wrong with it? And finally, sprockets? whats the recomended milage before change, i know theres things to consider like condition and `mad riding` but just a rough idea as to how long…

Hello all I am looking for all the help i can get I am looking for a list or knowledge of what part are interchangeable for my 1985 XJ750 Maxim X my bike is in great shape but cant find anything in Canada for my bike i keep getting good luck that does not help So any help would be great

John will like this one.....

Evening All I have a 2nd question in as many days... Yam xvs 650 1997 front brake master cylinder kit Does anybody know if/where I can get some new seals for front master cylinder as Yamaha want to charge an arm, a leg and a pint of blood.. In their infinate wisdom Yamaha made these seals VERY special.. My brake seal stockist says that on measuring the 2 seals some dimensions are metric and some imperial My measurements for the 2 seals are... 1st seal (small) is od = 13mm,,,,,id = 5.75mm,,,,,, height = 3.5mm 2nd seal (larger) is od = 13mm,,,,,id = 7.8mm,,,,,,, height = 4mm Hope someone else has had the same problem and found a solution cheers To…

hi all can any one tell me if the starter relay is broken on my bike. when i try to start it all it does is buzzes at the starter relay/positive terminal and you can feel it vibrate. all i have done is change the battery to a new one as old one was goosed.also where do i get a starter relay from? cheers for any advice/help in advance friedegg ps it is a x plate 2000 year

Hello, My name's Steve and im new I live in Derby and am looking into getting a new bike to get me from Derby to Nott's on the weekdays and then out for fun on the weekends. I used to have a Derbi Sender a few years ago but got rid as soon as i got my car license and now see that wasn't such a good idea. I'm potentially looking into getting a WR125X, thinking maybe in black or maybe white. Just looking for some opinions on them really, i will be mod'ing it a little bit, having quite a big background in car modifications so it wont stay stock for too long but im wondering what potential they have as well? Regards Steve

Hi ppl, just new on here, couple of friends said your all very helpful so i thought i would look you all up, ive got a gearbox problem " i think " on my 2002 r1 5pw, am having trouble finding gears the higher the gear and the faster i go the problem gets weirs could some one help me please . thanks ..

can anyone tell me if full givi luggage system from an fzs1000 fazer will fit onto a new 2008 fz1s fazer