drewpy

are the carbs clean inside, ie all the small jet holes unclogged?

lube your cable if its not a slinky coated one, or just replace it. Readjust the cable and check the run is not near an exhaust pipe where it will burn

it also depends on the handle bar shape. American bars tend to have higher, curvier bars so there are shaped to meet those curves. TBH so long a the bore size is the same, you should be ok. try xs650 stuff off mikes XS

I never forget undoing a cam cover bolt on the FZ using a ratchet ring spanner. going great till it hit the frame with no where else to go. had to cut the spanner with an angle grinder. I feel your pain

I'm suprised its finicky then. I'd still check timing, fuel height, valve clearance . before you start on different jets. BTW fuelling the top end still applies, get that right (over 3k) there' usually a transition around there from pilot

check timing if its adjustable first. check 2 stroke oil as too much weakens the mix you need a jet kit, allens or NRP, you need to ensure mains set first for WOT, do plug chops to check mix. I assume the carb is set up and cleaned throughout?

the xsr looks great

I would check fowlers parts fiche and see it its labelled there

on the carpe-tdm site, one really tall guy has slightly modified his controls and this helped http://www.carpe-tdm.net/ipb/index.php?showtopic=37015&hl=tall#entry376858

my tdm850 is tall. I have a Hagon shock on though which does raise it a bit. have to lean the bike slightly to put foot down.

usually an earth fault. strip and clean

Irish Karl.

I'm sure they didn't do it on purpose then. Sounds like a decent shop

to the YOC

not good, nip over to new members section and introduce yourself first. might get a better response

Mr Stew

inn

hard luggage for me too, when I went to spain etc, just unhook them at destination and walk in like a suitcase. they are safer like Cynic says so brew stops are less fraught . Say hello on http://www.carpe-tdm.net/ipb/index.php loads of info for you there too

stephanie key thing is to relax on the bike, everything becomes smoother then