Jump to content
Sign in to follow this  
Lorne Malvo

Fault code 19 on my YBR 125

Recommended Posts

I have a 2014 YBR 125 and have just had it fixed because there was no power getting to the dash or ignition, despite the battery being fully charged and ok (apparently it was a dry joint in the wiring!?). However, after getting it fixed and starting it a few times, when I try to start it now, it just spins electrically (figure of speech) but doesn't kick into life. I then get the engine management light giving 1 long flash and 9 short flashes, which I am told is error code 19. Can anyone give me any advice on how to fix this problem please?   

Share this post


Link to post
Share on other sites

There are loads of sites out there that give you the code readouts yours is ;- Fault code 19 - No signal from ignition to ecu. So check the wiring from the ignition to the ECU and see if you have a broken or rusty joint.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...