Airhead

wot no more chips!!!!!?

to bleed the pump just remove the bleed screw, oil and bubbles will come out the hole...replace the screw when the bubbles stop

Greetings ausibatla and sorry to see you got off to a bad start fella but dont worry this isnt normally a place you'll get aggro from they're a friendly bunch as a rule I can see where you're coming from with the spoked wheels they look far better on this type of bike in my opinion.

I asked is it sparking?? when you fitted the new piston did you have the arrow towards the exhaust port direction? does the scoot have reed valves and are they ok?

Horse searches for family in TESCO For the Americans...they found horse meat in TESCO burgers ...tut tut!

JUNK!!! what is your old man devoid if any sentiment, far from junk It's a thing of beauty in my eyes and sure looks in good nick too Myself I would strongly suspect the magneto side crank seal needs replacing Greetings and

Greetings careless yeah sure it wont kick you in the ass fella, but nevertheless it should rev out

Great choice James, welcome in

so what did you see was wrong with the old piston? that comment about......... " but now i hae just noticed that petrol is spitting out or the hole closest to the center or the bottom as you look at it from the air intake side"........ just doesnt make any sense, what are you saying here then? is it sparking?

it looks challenging but there again I've seen worse...you dont see many of those around eh

he's never stayed steve

well with the threat of snow on the way the TTR is going for an MOT tomorrow, not used it for more a year...fingers crossed

Check your battery connections, connections to the starter and any earth connections particularly to the engine

Greetings Rossco and

kinell...not many o those around, now I get ya...youre saying I pointed a 0.25 your way in the past eh

Oohh I need a lie down

Its 0.25 not 0.0 ?

Greetings Haley...Great choice

Ahh just give it a rub with some wet/dry and fit this little badly listed beauty http://www.ebay.co.uk/itm/NOS-YAMAHA-DT1275-GENUINE-PISTON-0-25-/261107092166?pt=UK_Motorcycle_Parts&hash=item3ccb320ac6 Seriously...It'l be cheaper than a rebore and pattern piston, the bore would have to be buggered to not give this due consideration IMO

True merv true, I'll settle for the last one

It'll be a lot simpler than your 3 phase one preload

Greetings Steve it's a miracle youre still with us let alone still biking

If one is black thats a ground or chassis wire. The other probably feeds the headlight, does your headlight only work when the motor runs?

Slightly different mountings Andy, maybe with some cutting and welding...the earlier pipe sure is a good one I agree, the only downside is the weight but so what