jkichline Posted May 24, 2007 Share Posted May 24, 2007 Last night I changed the plugs in my FZR 600. I tried to start it this morning and it wouldn't start. I killed the battery trying to start it so I hooked up my charger. I finally got it to start running but it only ran for a minute before it stalled. I could not restart it. The RPMs were very low when it was running. Usually (with choke on) it revs up after a few seconds. But it ran around 1K rpms for about 60 seconds. I had the bike out a couple weeks ago and it ran fine. I'm positive I have the wires in the right positions. I reseated them this morning but it didn't change anything. I have it on a float charger today and I'll try to start it tonight when I get home. Any ideas? Link to comment Share on other sites More sharing options...
Moderator YamaHead Posted May 24, 2007 Moderator Share Posted May 24, 2007 Plugs gapped correctly? Link to comment Share on other sites More sharing options...
steve.m Posted May 24, 2007 Share Posted May 24, 2007 Just a thought but have you disturbed any vacumn pipe's and are any pipe's trapped Link to comment Share on other sites More sharing options...
jkichline Posted May 25, 2007 Author Share Posted May 25, 2007 I set all gaps before I put them in to .028". I dunno if I disturbed any hoses. I'll check that this weekend. Last night, I tried to start it again. I got it running but I could not give it any throttle without stalling. RPM's never crossed 1K. Link to comment Share on other sites More sharing options...
jkichline Posted May 26, 2007 Author Share Posted May 26, 2007 Its running !! I forgot my main fuel does not work. I have to have the valve set to reserve. I'm guess the main fuel straw is either clogged or there is a leak in it. I set it to reserve and it runs like a champ. Link to comment Share on other sites More sharing options...
Recommended Posts