i have acquired a intruder 125 and have found some problems...

the solenoid is gone which i have ordered

there is a loose connection in a wire from the ignition barrel

also the bike will start when i bypass the solenoid but only with the choke on

it wont run even when warmed up (tick over or accelerated)

i see this problem as the carbs but i dont know how to regulate the mixture

anyone have any advice?

thanks in advance

b..u..m..p..

Dan I assume you are asking for advice about the 'only runs with choke'...this is often a blocked pilot jet, strip and clean the carb thoroughly paying particular attention to this jet.

Suzuki D.U.M.P. :D :lol: :blink:

its not mine lol someones paying me for working on it ive bought some carb cleaner and will take your advice

thanks oldgitonabike

Suzuki D.U.M.P. :D :lol: :blink:

How very dare you Merv!

Good luck Dan.

Well funny you should say that we had a thread on the aircooled forum the other day, what is the worst bike you ever owned and most of em where Suzukis,

ok carbs done but no cigar...

air filters are off

loud knocking in front cylinder

as soon as i accelerate it misfires then cuts out

but will accelerate upto about 3000 rpm when the choke is slightly on

any ideas? im at the end of my knowledge

yea, give it im back ,

and tell im to buy a yam.