Hi, Hopefully there is a wizz kid out there who can diagnose this problem I have:-
A few months ago the thrust bearing on the clutch went so I replaced it.
All has been well for a month or three then low and behold it went again. When I removed the clutch housing it was almost dry inside apart from a load of froth, (it looked absent of oil. which I thought was strange) anyway I have cleaned everything up, soaked the clutch plates in oil for a week replaced the trust bearing AGAIN! and put it all back together; - here's where the second problem arose, no matter how much I try to adjust the cable, at the clutch end and at the lever end, the clutch will not disengage, when I put it into gear whilst up on the full stand the back wheel goes around as you would expect, but, when I pull in the clutch lever the back wheel still goes around, and it doesn't slow down at all, it seems to be still in gear, when I rode the bike, the weight of the bike and me was enough to stop the bike travelling when I disengaed the clutch, obviously there is something not right but for the life of me I cna't figure out what it is. Can any one throw some light on it please?