The Bar

My friend Andre is looking for a bike. He's 20 in a few weeks and I was either looking into getting him a bike (Would have to be dirt cheap) or helping him find a bike. Does anyone have any suggestions as to WHAT bike he could get nice and cheap? Does anyone know where to get said bike in london? Much love to you all!

Hey. I wonder if anyone know about any general problems with the yamaha 125 dt bike ? Anything you have to look after when you are bying one? Im on the edge of bying one. I already have a Virago 125 but think it had been fun with a dt in the garage. Pleas need answer Steffen

does anyone no wer i could get the fittings to mount a box to the back of my yamaha tdr 123 2003. ???

Hi, I am Tim from Ontario Canada, I am glad to have found this fourm. I just purchased a 1979 dt100f Can anybody advise where a good spot to buy parts ? most of my bikes I have found special stores that carry everything I ever needed. I am looking for the same for my new dt100 I was searching for a stock decal set and a new 6 volt headlight bulb and have just been driving my self crazy seaching the web and ebay Can anyone help? Thank you in advance regards tim [email protected]

hi i have got a tdm 900 on a 03 plate i am have in problems wireing it up i have power but can not find the signal wire for neutral any help would be great i just hope some one has done one and can tel me were all the wires go thanks for any help

For some reason i'm not allowed to post in the for sale section

Hi, i went out to the garage the other day to finish up my project bike, bleed the brakes and what not, which is when i found that my rear Calliper was completely seized on the FZR. I either need to know what Calliper will fit on it (its an L reg bike) Or need to know if anyone is selling a like for like replacement? I'd like to be able to put an R6 brake on it, but don't know whether it will fit.. It has a lot more power than it would of as standard so yeah want to update it but not worried if i can't. Cheeeeers Best off to email me on [email protected]

does any body know if the Yosimura exhaust for the honda c90 will fit a yamaha townmate, i think the cubs down pipe is 32mm.

hi am new to this site just trying to source fairings for my bike preferably primed ready to custom paint, i dont wana strip down the originals due to work commitments and sentimental values any help would be apreciated jamie

Heres some useful topbox info for TDM850 and probably topboxes generally. I bought my bike in October (just in time for winter!) and needed a topbox. Looked at Givi but didnt want to spend £200-£300 on Givi brackets, plate and box so managed to come up with a comprimise. The Givi brackets are essential as they are taylored to the bike and think they are the cheapest out there - about £80 from Mad4Bikes for TDM850. Fitting it isnt for the faint-hearted and be careful not to dismantle more than you have to - huh-hem! Givi sell a seperate plate (about £40) but i didnt need this in the end. The topbox i bought was a huge Tech7 48litre jobby which you can find on Amazon. For £…

hi any one no were starter clucth is on fzr 400 many thanks

Hi all, Jw if anyone else on here also owned a 1987 dt125. I ask as I'm after some up close pictured, ie both sides, front and back as I want to see ways missing of mine, can anyone help???? Cheers

hi all any one no were the starter clutch is on my fzr 400 87 model many thanks

hi, i have a YBR125 '61' and have bought the official Yamaha LED blinkers - http://www.yamaha-motor.eu/uk/accessories/?productCode=YBR125&redirect=false - installed them as it shows.. indicator with the resistor in parallel with it and they supply 2 10ohm resistors, i have installed front and rears of these and they flash too fast and are illegal at the speed they flash. does anyone know of any ways to sort out the speed of flashing without installing a new relay? i have tried installing more resistors but still doesnt seem to help. the original bulb indicators were 10w/12v and my battery is 12v. any advice will be much appreciated. thanks. Oli.

hi all,i have a sachs roadster 125 and wondered if anyone (paul white)had any idea if the forks off any other bike would fit this model or what make the forks are.info on these bikes is not easy to find. thanks craig

Hi, not been on here in a long time, but this has come to my attention today, and given its importance i'd like as many off you to sign it as possible. If you think the new test rules been brought in in 2013 are unfair then please please please sign this pertition. http://epetitions.direct.gov.uk/petitions/27455 Thankyou

i have a new exhaust in my garage pre fix 3bw is this a dt125 or 200

hi i've got a Yamaha DT50R 50cc moppet. its made in the year of 1992. i want to replace my engine block with the engine block of a Yamaha DT50R from the year of 2006. can i jsut yake out that 50cc block and place on my frame without any ajustments made on my 1992 frame. please help me, i'm really desperate. thanks

hey am looking to replace fairings etc on my yamaha yzf600 r 03 thundercat just wondering if parts from and r6 r1 and possibly the fazer seing they are along the same designs will fit my bike any help will be apreciated , jamie

hi there i have recently got a fzr1000 fighter but need some bits to finish since having the fairing removed the radiator doesnt look very good does anyone know what radiator would fit and that suit it better ? also anyone know where to get cheap top yokes to take custom bars etc ? all the ones i,ve seen have been 150 pound plus