lwpFJ1200 Posted April 4, 2008 Share Posted April 4, 2008 Hey I have an FJ1200D from 1992 witch has a lot off vibrations, I have found that the bolts tighten the lover fream pips was loss! The loss bolts has been renoved, but I need to find the tighten recomandation for adjusting off the Stopper damper abowe and under the chain?? Best regards Lars Walling Link to comment Share on other sites More sharing options...
FJ12SP Posted April 5, 2008 Share Posted April 5, 2008 ???? Sorry dont understand. Adam. Link to comment Share on other sites More sharing options...
lwpFJ1200 Posted April 6, 2008 Author Share Posted April 6, 2008 ???? Sorry dont understand. Adam. HI Adam I can see that you have done some re-building of your FJ12, it is very lovely. I'm looking for the tighten instruction for the pos. 10 "Stopper damper" Lars Link to comment Share on other sites More sharing options...
FJ12SP Posted April 6, 2008 Share Posted April 6, 2008 Hi Lars Yes I have totaly re-built my FJ. The Clymer manual states that these bolts have to be torqued to 48nm, but I would advise caution here. When I striped my frame I found that 3 of the 4 bolts you describe had sheared due to vibration, I had mine drilled and re-taped oversize. Its very important to keep the carbs set up correctly (Balanced) as poorly balanced carbs will cause excessive vibes. Hope this helps Adam Link to comment Share on other sites More sharing options...
Recommended Posts