jcr Posted June 16, 2022 Share Posted June 16, 2022 i have just started to get clutch slip when the bike hits the powerband. the engine is on 34500 miles. so im guessing new friction plates and springs. are the EBC rebuild kits on Ebay good to use or should i go to for oem? not near a Yamaha deal which is annoying. Link to comment Share on other sites More sharing options...
finnerz89 Posted June 16, 2022 Share Posted June 16, 2022 What bike are you talking about? Link to comment Share on other sites More sharing options...
jcr Posted June 20, 2022 Author Share Posted June 20, 2022 a Thunderace. i went with oem from Yamaha in the end. folks on exup forum have reported problems with EBC stuff. Link to comment Share on other sites More sharing options...
blackhat250 Posted June 21, 2022 Share Posted June 21, 2022 I"V used the EBC plates and springs,, with no probs,, but my bikes are low horse power machines , Link to comment Share on other sites More sharing options...
Moderator mervin Posted June 21, 2022 Moderator Share Posted June 21, 2022 Always check EBC or any new plates for thickness from new , a freind put new plates in his RD400 and the clutch started slipping, he changed the oil to sae30 mineral , replaced springs with heavy duty ones , still slipped , he took new plates out again and measured them they where too thin , he put the old plates back no slip Link to comment Share on other sites More sharing options...
Recommended Posts