Ogwen Posted March 7, 2014 Share Posted March 7, 2014 Hi everyone, I've read the chain thread that is pinned above, and I am happy tackling it. I have a garage with light and power to do the work, and plenty of tools - I could just do with tips on what tools are needed to swap everyting over? I'll consult the Haynes fairy story manual but I'd rather hear from someone who has done the job:) I've found a place that will do the chain and sprockets set for £40 delivered whichs sounds ok Any help gratefully appreciated. Cheers Ogwen Link to comment Share on other sites More sharing options...
dt502001 Posted March 7, 2014 Share Posted March 7, 2014 It a simple straight foward job,loosen the front sprocket bolt first before removing the rest, if it's the factory chain then you will need a chain breaker or grinder to open the chain to remove it. When installing the new chain if using a split link the heel (closed) end goes in the direction of travel. Link to comment Share on other sites More sharing options...
Ogwen Posted March 7, 2014 Author Share Posted March 7, 2014 Have grinder so that solves that problem:) - Thanks for your response Link to comment Share on other sites More sharing options...
dt502001 Posted March 7, 2014 Share Posted March 7, 2014 No problem,but if you intend on riding for a few years then buy a chain breaker they are cheap and make life so much easier. ESP when the new chain comes and is too long. Link to comment Share on other sites More sharing options...
Moderator Airhead Posted March 7, 2014 Moderator Share Posted March 7, 2014 on such a low power bike you may not need the grinder! Check to see if theres a split link fitted, even if there isnt I'd fit one on the new chain myself Link to comment Share on other sites More sharing options...
Ogwen Posted April 1, 2014 Author Share Posted April 1, 2014 Hi all, the chain and sprocket swap is done! I used the grinder for the chain no problem, and plenty of plusgas to loosen the bolts on the front sprocket cover. All good! Next job, headset bearing.... 2 Link to comment Share on other sites More sharing options...
jimmy Posted April 2, 2014 Share Posted April 2, 2014 Well done mate. The wee jobs give you a bit of satisfaction 1 Link to comment Share on other sites More sharing options...
Recommended Posts