Jump to content

XT250 Steering bearings


mcferreira100
This post is 3997 days old and we'd rather you create a new post instead of adding to this one. You can't reply in this post.

Recommended Posts

Do you want an ad-free experience? Join today and help support the Yamaha Owners Club.
  • Moderator

....As long as you have the correct number of balls I think you should be okay. ??

I think Sacha has if right here. Use the right number and the right size. A quarter inch or 6mm is pretty standard but you need to check that. Once you get the size you can buy them off fleabay very cheaply. They need to be packed out with grease as well. It is a pain to replace them so I would do it once and do it properly.
Link to comment
Share on other sites

New race did not fit properly so will replace the set with 22 as per the manual.

Link to comment
Share on other sites

Top tip...missing race was sitting stuck inside the stem...now I know where to find the little buggers that go missing.

Link to comment
Share on other sites

  • Who's Online (See full list)

    • There are no registered users currently online
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...