ahaywood93 Posted May 26, 2013 Share Posted May 26, 2013 when i attach my clutch puller and try pulling my lever nothing happens it just dont feel like anythings happening i think i lost the push rod and bearing when disassembling the engine is that what it would be? and its not sparking for some reason the only earths i did disconnect i have cleaned up and reconnected ive lined the timing up on the transmission cogs the dots are next to each other and the stators seated on the wood ruff key fine its really puzzled me Link to comment Share on other sites More sharing options...
ahaywood93 Posted May 26, 2013 Author Share Posted May 26, 2013 ahhh i didnt adjust the clutch plate screw or line the dots up on there i just put it together and started screwing the springs in do you recon thats why the cluitch puller feels like it dont do anything Link to comment Share on other sites More sharing options...
Moderator DirtyDT Posted May 26, 2013 Moderator Share Posted May 26, 2013 Could be. Also you may need to make sure that the spindle that the puller goes on is fully turned in the direction that the puller pulls in before you line the rest up. Link to comment Share on other sites More sharing options...
ahaywood93 Posted May 26, 2013 Author Share Posted May 26, 2013 what spindle do you mean hope i dont have to split my engine again Link to comment Share on other sites More sharing options...
ahaywood93 Posted May 26, 2013 Author Share Posted May 26, 2013 is it the one in the middle of the plate that screw? Link to comment Share on other sites More sharing options...
Moderator DirtyDT Posted May 26, 2013 Moderator Share Posted May 26, 2013 You should loosen the nut in the center of the clutch. Push the lever to the front. Move the center adjuster until the marks on the case and the lever align. Tighten the nut up. This should work assuming you have assembled the clutch correctly, not forgetting the little ball between the push rods. Link to comment Share on other sites More sharing options...
ahaywood93 Posted May 26, 2013 Author Share Posted May 26, 2013 yeah thats the problem then going to do it now need to find out why its not sparking next recon its because i haven't lined the dot on my clutch plate to the one on the basket? Link to comment Share on other sites More sharing options...
Moderator DirtyDT Posted May 26, 2013 Moderator Share Posted May 26, 2013 Sparking will be a different issue. Link to comment Share on other sites More sharing options...
Recommended Posts