ahaywood93 Posted May 11, 2013 Posted May 11, 2013 Ive put the power valve on the 170 barrel and when i tighten the outer casing and tighten it the valve wont move atall untill i untighten the 2 bolts any ideas?
ahaywood93 Posted May 11, 2013 Author Posted May 11, 2013 would it be better with the valve out completely?
ahaywood93 Posted May 11, 2013 Author Posted May 11, 2013 should i send it back and get a new one? it has a 60 day guarantee
Moderator Airhead Posted May 11, 2013 Moderator Posted May 11, 2013 Could it be something you've done wrong or set up wrong...rather than a manutacturing fault?
ahaywood93 Posted May 11, 2013 Author Posted May 11, 2013 could be ive never set one up before on these bikes ive followed the instructions that came with it and i took my old one apart but ill do it again tomorrow double check
ahaywood93 Posted May 11, 2013 Author Posted May 11, 2013 yeah i think ive put it inside the barrel wrong the servo tells it to do a cleaning cycle when i switch my ignition on so im guessing i flip it and go from there
ahaywood93 Posted May 12, 2013 Author Posted May 12, 2013 power valves working perfect and is set up correctly just need to wait for my bearings and put her all back together
Recommended Posts