TheBoltons Posted September 26, 2012 Posted September 26, 2012 Not been on for a while and missed loads of posts... Been in and out of hospitals etc many times thanks to the National waste my effin time with no regard to your Health Service... But... SR engine completely stripped down to nothing, crankcase rebonded, all gaskets replaced, everything cleaned to a shine and oiled, and she runs!!! Annoyingly, doesnt like idling again, which is the problem I had and rectified before... Then took it to pieces again :-S I have noticed though if I apply the tiniest mouse fingered throttle, it idles like a dream... Throttle cable has a wee bit of play too, so should I just tighten it a little?
Moderator DirtyDT Posted September 26, 2012 Moderator Posted September 26, 2012 ...................Been in and out of hospitals etc many times thanks to the National waste my effin time with no regard to your Health Service.................... Easy Tiger..............................they pay my bills and pay for my bikes. What idle speed does it idle well at?
Moderator Cynic Posted September 26, 2012 Moderator Posted September 26, 2012 Be very careful taking slack from cables if they are tight you may find the bike accelerates when you move the bars. Not good.
Moderator Airhead Posted September 26, 2012 Moderator Posted September 26, 2012 why not just turn the throttle stop screw in about 1/4 of a turn? After all that's what it's for
Recommended Posts