Search the Community

Hi - I popped my 2000 TDM850 over to the local garage saturday and used the jet wash being very careful not to point it anywhere vital. Afterwards all was well (and clean), I lubed the chain, and took it out for a run and didnt have any problems. Didnt use it Sunday but this morning I started it with choke which normally runs the engine at an extra 500-1000rpm depending on how much choke. But...after about a minute, and without touching the choke, the engine slowed to normal idle. Once it warmed up I took the choke off and it sounded like it was running on one cylinder only and had to use the throttle to keep it running on both cylinders. I figured if it was moisture, the run to work would clear it, but still wouldnt tickover at work. So in short - once warmed up - its running on 1 cylinder at idle revs and stops. Any suggestions? (apart from dont use a f*****g jet-wash!) cheers