Joeleol

Hi all, Just a quickie, I have acquired some of the lovely (looking) XS400 '80 wire wheels, both drums. The front is the twin leading shoe model (if anyone has these?) I was just wondering how good they are? I know they are going to be worse than disks, I am only interested in fade characteristics and life of the shoes. Thanks in advance, Joel

Haha! Me too!

The '79 XS 400 has everything you want. I just bought the whole setup from the states =) The front has a nice twin leading shoe design,

Hello all, I'm currently looking for my next project as the 250 is not far from finished now. (I got some wire wheels off the bay for £50 wohoo) Preferably something nice, old and oh a complete pile! I don't want to spend more than a grand so any ideas? Thanks in advance, Joel

Tachometer is 5:1, found a sweet veglia one!

Ok, thank you, I will measure the ratio myself (I was just being lazy) and let everyone know.

Bump! Helppp please

Hi PorkChop, I would pack it as per the manual. I didn't think to check the quantity when I rebuilt mine. When the clutch lever is fully disengaged there should be no play in the plates whatsoever (i.e. they wont rattle). So just do whatever it takes to achieve this.

Just off the top of your heads, does anybody know what ratio the speedo drive and rpm output drive are on the xs250? Thanks in advance, Joel

Where can I get a timing kit like that for my XS250 (its the same as the 400 I believe) I really hate points.

Its some light bronze metallic colour, It was the colour of my last bike and I thought it would look good. Now its done, I'm not over-keen, but its different so I think its going to stay like that for now.

Thankyou! The black paint is halfrauds high temp black and the silver is krylon hightemp radiator paint (we use a lot of it in F1 . Yeah it has been completely rebuilt, new bearings, reground nearly everything, its like brand new but better

A few more.. BIKE BEFORE BIKE BEFORE 2 BIKE BEFORE 3 FRAME PAINTED ENGINE IN ENGINE IN 2

And best of all it's not a question! Its a quick update on my project. Here's some eye candy...(for me if not you!) ENGINE BEFORE ENGINE BEFORE AGAIN ENGINE AFTER

Ahh, what kind of dimensions do they operate in and how many axis? I can always do a two or three part mould =p (I'm just being a cheapskate really, 5-axis machining around here is £45+ per hour =(