DTsteveo

Paul, Many thanks again i certainly have my weekend organised now regards Steve

Hi paul, Many thanks for the advice i will have a look at those parts, The clutch (or lack of)as soon as you select 1st gear it just stalls, is it likely to free up with use or will i have to free it up first? Regards Steve

Hi guys, Hope you can help, i have been left a DT175 not sure if its an mx (have been advised its 1980s) by my late brother in law i have had to have a rebore of cylinder so new gaskets cylinder kit etc,and now have all intake rubbers that were missing. It has stood unused for maybe 3-4 years and have couple of snags The engine starts and runs from cold then after a short while it dies and fuel comes out of carb overflow port,i have taken carb off to check for dirt in float chamber and cleaned it out but still does it, any suggestions? Also bike goes into gear but no clutch control at all ,(clutch linkage moves )some one has mentioned the clutch basket but this sounds expensive and complicated and i have limited mechanical knowledge Many thanks Steve