drewpy

Hey, Happy B Liam

Nev, I can't be arsed looking, can you get me a link for this ebay web site? I looked everywhere on the computer

twit N a Barm methinks

I'm sure you can get dogleg levers from busters or M&P

holty

here's the link

barnsey

yay for sheds and their inventors

AYE!

in my yam manual for xs400, it says pull chain out (half way round on the rear sprocket) If it lifts more than 1/2 chain link ,its worn!

settings are wrong :lol:

TBH i was crapping meself, gets a bit nervy when you see all that tarmack and you know your gonna be gunning it the next few mins with those racers chasing you!

I wonder if your getting a weak spark and closing the gap is just compensating for it. I am running points, but only as a trigger for electronic ignition which was homemade from an enthusiast in germany! I have those iridium plugs and haven't changed/adjusted them for a few years and still going strong. I did have some coil issues but replaced them with a set off ebay with a 3ohm set. £13 each they were and bolted straight on. which tip did you break off? mains or pilot?

buon compleanno mate

thank god for that, can't wait to see this problem sorted

it look s like a strip down to me. gears are worn

YAY got front page on the Barnsley bikers web site, Mike is behind on the honda

I am assuming they are wire wheels then? you need to get the specs for the SR which I do not have, if you already have an SR, why not offer them up and see if the difference.

its the T shirt that is upside down

it is the amount of "time" ie degrees angle over the circumference of the shaft the contacts are closed. This charges up the primary coil and when the points open, the electricity has built up so much in there that is inducts into the seconary and through the spark plug jumping the gap. the more the coils are energised the fatter the spark.

if you go to the meet, you have the pleasure of his company

so we got 8 up to now!! Its hard work getting peeps to commit Paul. I'd also ask peeps to pay up front as, good as their intentions are, it gets "forgotten" or "computer broke" or some other excuse which still leaves you out of pocket! I occasionally still get a PM saying I forgot where's my patch!!

Not quite, dwell is the time the points are closed,so its the opposite. told you these carbs are finicky, are you really sure those tips have not broken off, can you see daylight with the carbs off and mix screw out? the only other thing is the float bowl has a fuel run and it did take me a while to ungunge it using compressed air, solvents etc. drewps

its under this very heading pinned at the top! He's from Breitmet, ask him yourself!

must come to the YOC meet in September. up.yours is bolton way and I'm in Eccles along with Oldtimer who lives near the east lancs/swinton. I got a new job so have to occasionally work weekends at short notice. but looking to go to Stafford 1st weekend in july for the VJMC show if you like classics and a ride down the A roads? (and if the weather's nice'ish)