[email protected] Posted May 25, 2020 Share Posted May 25, 2020 Hi, I have just bought my first MC, a Yamaha Fzr 1000 year 1989. I want to purchase a complete engine, disassemble, and rebuild with new parts, bearings etc. My question for you Guys is. From which year to which year is the engine the same and fit my 89' fzr 1000? Thank you in advance Best Regards from denmark Anders Link to comment Share on other sites More sharing options...
Moderator Cynic Posted May 26, 2020 Moderator Share Posted May 26, 2020 Why? FZR1000 motors will do megga miles with just basic maintenance so long as they haven't seen a racetrack. The cost of doing an engine like that would cost a fortune. Link to comment Share on other sites More sharing options...
[email protected] Posted May 26, 2020 Author Share Posted May 26, 2020 Firstly my bike has driven 60.000 km, but it could be as high 80.000 km because of a dashboard change so i don't know for sure. Secondly i enjoy the proces of disassembling/assembling motors. The economy is not important. Best regards Anders 1 Link to comment Share on other sites More sharing options...
Moderator drewpy Posted May 26, 2020 Moderator Share Posted May 26, 2020 wow, I've spent a small fortune on just the top end of my TDM £90 just for a head gasket and that's for a twin cylinder bike. Link to comment Share on other sites More sharing options...
Moderator Cynic Posted May 27, 2020 Moderator Share Posted May 27, 2020 Yep, was over 600 quid to do the top end of my tdr after it blew with either oem equivalent or oem parts. Over 40 quid for the (non genuine used Athena) head gasket on a 2 stroke!! Could not stretch to the pistons though. Went with mitaka, genuine are well over 100 quid each plus as much again for the rings. For me I would tear down the fzr engine in the off season, clean it and check it. Good money says a lot of it will be comfortably in spec, 4 stroke bike engines, (especially big ones) usually are because even though you think your riding it hard. Your not, if you had the engine to its limits on normal roads you would be in hospital or prison before long. My neighbour rebuilt his 60000km vmax motor and all he changed was the starter clutch and the timing chains. Even the cams were fine. Obviously rebuilt with all new perishables, but otherwise job done. Link to comment Share on other sites More sharing options...
blackhat250 Posted May 27, 2020 Share Posted May 27, 2020 Welcome Anders",  i like your enthusiasm ,,,,,, Link to comment Share on other sites More sharing options...
pilninggas Posted May 28, 2020 Share Posted May 28, 2020 80000kms should be fine on an FZR1000 engine. as said above I'd avoid doing a rebuild - the costs are eye watering and as some of the parts are out of production by yam, so you will spend time sourcing parts elsewhere. Even if the 'economy is not important' don't end up blowing so much money you could have bought a fitter newer bike instead. Many of those era Yams with 5 valves burn oil (valve stem seals leak) so that might need doing but it is a top end job [and the valve clearances too]. My EXUP has 63000kms and although the engine isnt particularly quiet (they sound harsh by most standards), it's good to go. I find it's chassis and brakes that need more care on these things at these higher mileages (km-ages) and if the engine is good focus on these. Link to comment Share on other sites More sharing options...
Recommended Posts