David pittaway Posted January 19, 2019 Posted January 19, 2019 Hi all Help needed I’ve stripped and rebuilt my fzs600 had it running today running a little rough I’ve channged the air box to k&n cones so I think carbs need retting way jets should I use also I can’t remember we’re the little hose goes from the rad could some one point me in the right direction cheers Dave
Moderator drewpy Posted January 21, 2019 Moderator Posted January 21, 2019 could be just over flow pipe
David pittaway Posted January 21, 2019 Author Posted January 21, 2019 Hi drewpy I did think that but if it’s not connected it will keep running fluid out I thought I took a picture
finnerz89 Posted January 21, 2019 Posted January 21, 2019 Hi drewpy I did think that but if it’s not connected it will keep running fluid out I thought I took a picture [emoji2962]Whereabouts does it go to on the rad? Does it attach underneath the filler cap?Sent from my SM-G950F using Tapatalk
David pittaway Posted January 21, 2019 Author Posted January 21, 2019 (edited) No the filler is a separate piece. The pipe I’m on about is just underneath the top hose on the rad Edited January 21, 2019 by David pittaway Wrong
finnerz89 Posted January 21, 2019 Posted January 21, 2019 No the filler is a separate piece. The pipe I’m on about is just underneath the top hose on the rad Should it connect to the carbs? Could be a warming hose, or the oil cooler if it has one?Sent from my SM-G950F using Tapatalk
neversaydie Posted January 21, 2019 Posted January 21, 2019 Looks like it passes over the carbs and under the tank, so maybe connect onto the carbs at the rear perhaps/
David pittaway Posted January 21, 2019 Author Posted January 21, 2019 Cheers bud I’ll have to take a look I thought it might have somthing in the manual but no such luck
finnerz89 Posted January 21, 2019 Posted January 21, 2019 From doing some googling, definitely appears to be for carb warming. You could disconnect both and blank them off. Unless you live in Alaska I can't see carb icing being a problem.Sent from my SM-G950F using Tapatalk
Moderator drewpy Posted January 22, 2019 Moderator Posted January 22, 2019 I did think carb, but the browser had a fit and wouldn't let me post. As its the works PC sometimes the photo doesn't appear.
slice Posted January 22, 2019 Posted January 22, 2019 Carb icing can occur at any time regardless of the outside temp, if you have the fittings for it then use it as it is usually only fitted to bikes that have been prone to it. This can also operate as an extra kind of preheater to help the bike run in cold morning starts, reduces the need for long runs on choke.
Moderator Cynic Posted January 26, 2019 Moderator Posted January 26, 2019 Warm days it won't happen. I have taken the heater circuit of my tdr with no issues unless there is really cold air. I had a 350 that was sensitive to ice. My DT is too but only when it's really cold.
finnerz89 Posted January 26, 2019 Posted January 26, 2019 I know my DT has it, mines still in use but I know plenty of people who don't bother with it without any issuesSent from my SM-G950F using Tapatalk
2 Wheels Posted January 30, 2019 Posted January 30, 2019 Aye, it's carb warmer, goes onto little steel pipe in-between carbs 3+4 (right hand side). The jetting you will just have to play around with it untill you get it right. Start from standard jetting and go from there.
Recommended Posts