ba249k Posted November 6, 2015 Posted November 6, 2015 I have a set of standard V-star / Dragstar 1100 rear pipes.I Have already chopped the ends off, to open them up and they sound OK with a deep rumble but not too loud.Looking into the cans there is a second baffle plate with four holes in it with a couple of small pipes attached.Could anyone tell me what is behind that ?If I shine a light into either end of the exhaust I can not see any shinning through? I was thinking of opening up the can and then baffling it back to the 1 3/4 x 9 1/2 inch pipe suggested on the V-star Wikki page.And then slash cutting them.Has anyone had any dealings with modifying stock pipes?Any info would be most useful.I am also planning to Pod the intake and re-jet at the same time.Cheers Baz
Noise Posted November 7, 2015 Posted November 7, 2015 This is what's in the stock pipes. Unless your good with a welder it's quite hard to gut themfully. Best to save up n get a set of vance and hinds.
Dickwad Posted July 28, 2016 Posted July 28, 2016 On 11/7/2015 at 4:49 PM, Noise said: This is what's in the stock pipes. Unless your good with a welder it's quite hard to gut themfully. Best to save up n get a set of vance and hinds. I agree, i've been down that road and to be honest they sounded a bit "wet farty" when I throttled off, so bought some Vance and Hines.
Recommended Posts