xv535 Posted August 31, 2015 Share Posted August 31, 2015 Hi All. Its been 3 years or so since I last posted on this site. In June I rear ended a van which spiked the brakes because a woman with 2 kids decided to cross the highway. Lucky for me the bike fishtailed and went under the back bumper at approx. a 30 degree angle. The front and back tires hit the vans back tires. The trailer hitch sheared off the left foot rest and somehow didn't take my left foot off. Luckily I only suffered a badly twisted back and walked away. The bike was not so lucky. The way the bike came down on the pavement it suffered absolutely no damage to the tank, fenders, saddle bags, forks etc. The collision did however bend the frame. To look at the bike when it is sitting on its stand it is hard to tell that it has been in an accident other than the fact that the left foot rest is sheared off and the shifter is bent as is the shift rod. The bike has 15,000 k's on it. The local Yamaha dealer has quoted $6,242 to repair it with the most expensive part being a new frame costing $2364 (includes tax). Is it worth while repairing this bike or should I buy a new one for $12,400 (tax in)? Because the shift rod was bent what are the chances that there is significant engine damage. Note that the engine quit on impact.This is a list of the parts needed per the Yamaha dealer:FrameDown Tube CompShift Pedal AssyShift Rodbracket for left foot restFlange bolt, crown bolt, shop supplies etcFront left foot restFront right foot restRight mirror assemblyCover where shift rod enters engineDamper 1 (?)Axle front wheel Thanks for your comments.Rocky Link to comment Share on other sites More sharing options...
slice Posted September 1, 2015 Share Posted September 1, 2015 Welcome back, just one thing for me to say really "bin it" buy a new one, that way your back on the road and don't have to wait around for months while it gets fixed then spend months going back and forth trying to get the bastard thing to run properly, cos with the best will in the world if the engine does seem ok but then gets a fault is it the accident or just wear and tear, don't even think about repairing it. Just sayin. Link to comment Share on other sites More sharing options...
Moderator Cynic Posted September 1, 2015 Moderator Share Posted September 1, 2015 Not being in the position of being able to throw thousands at a new bike i would be looking at buying a donor and making a good one from the pair.Maybe customise a little too. Will certainly cost less if you know how to work a spanner. 1 Link to comment Share on other sites More sharing options...
slice Posted September 1, 2015 Share Posted September 1, 2015 Sorry as above meant replace it not buy new! Link to comment Share on other sites More sharing options...
xv535 Posted September 2, 2015 Author Share Posted September 2, 2015 Hey Guys. Thanks for the comments. That is exactly the conclusion that I came to last night. I was worried that there could be undetected engine damage or some other problem that will affect the bikes handling. I have tracked down two bikes with less than 13,000 km on them for less than the cost of repairing my bike and I am meeting with the vendors on Wed. Thanks again. Ride safe. Rocky Ps. Cynic, on this side of the pond spanner = monkey wrench. Cheers. 2 Link to comment Share on other sites More sharing options...
Moderator Cynic Posted September 2, 2015 Moderator Share Posted September 2, 2015 So you wont be having a long pull on a fag afterwards then... 1 Link to comment Share on other sites More sharing options...
KevtheRev Posted September 2, 2015 Share Posted September 2, 2015 Yeah , don't ask to bum a fag over the pond . You might get a black eye !. 2 Link to comment Share on other sites More sharing options...
wild foamy Posted September 2, 2015 Share Posted September 2, 2015 Yeah , don't ask to bum a fag over the pond . You might get a black eye !. found that out the hard way in California... *shudder* 1 Link to comment Share on other sites More sharing options...
Recommended Posts