Nootenboom Posted March 7, 2015 Posted March 7, 2015 I have a XJR1200 1995 with new exhaust pipes and origonal silencers direct no more muffler collector box at the end of the silencer pipes there is a riveted disc with a small opening in the center is about just under 1 inch, the question is how big should I make it to get a bigger sound like on a Harley? any suggestions At the moment the rear section is riveted with 3 rivets so I could drill them out to remove the section to make a larger opening. my e mail is [email protected]
fabiostar Posted March 7, 2015 Posted March 7, 2015 it will never sound like a Harley, thank god lol.. just get a secondhand set of exhaust cans. race type and keep the standard ones good and untouched.
slice Posted March 7, 2015 Posted March 7, 2015 Yes as above, if you want a Harley sound then you need a Harley simple as that really. Remember that the Harley is OLD school ie tractor, the Yam is NEW school over square bore and stroke so you can't make them deep and roary as they are always going to be high revving and squirty bikes unlike the Harley which is all about torque and low down grunt.
Noise Posted March 9, 2015 Posted March 9, 2015 As said above, Also best to remove your email address too, never know who is looking on this forum
Recommended Posts