alexxx_mod Posted January 23, 2015 Share Posted January 23, 2015 Hello everybody! I'm from Ukraine and my English is so bad. I'm repair USSR motorbikes and now repair TDM 850 1st generation. This bike have a problem. Right cylinder shoot flame to carbs and exhaust. Syncronization carbs don't give any result. Cylinder head after repair. Electric parts work normally. Please, help me anybody! May be cylinder head need to adjust? Link to comment Share on other sites More sharing options...
slice Posted January 23, 2015 Share Posted January 23, 2015 If you have flames in the carb check the valve timing, it might be a broken valve or just need adjusting. Link to comment Share on other sites More sharing options...
alexxx_mod Posted January 23, 2015 Author Share Posted January 23, 2015 As I understand it, in my case broken intake and exhaust valves? We have flames in the carb and in the exhaust. Engine chain has a beginning and an end chain? It has some sort of label? Link to comment Share on other sites More sharing options...
Moderator drewpy Posted January 23, 2015 Moderator Share Posted January 23, 2015 could be a valve timing issue, ignition timing or carb is too rich causing the unburned fuel to ignite Link to comment Share on other sites More sharing options...
alexxx_mod Posted February 3, 2015 Author Share Posted February 3, 2015 Сan I diagnose this problem without disassemble the engine? Link to comment Share on other sites More sharing options...
fabiostar Posted February 7, 2015 Share Posted February 7, 2015 have you checked the compression reading on both sides to make sure they are the same incase it has burnt a valve out? Link to comment Share on other sites More sharing options...
Recommended Posts