jackm20010 Posted September 9, 2013 Share Posted September 9, 2013 Hello,I have a ybr where I have to pull the clutch in to start the bike in neutral and have the side stand up, not a bad thing however I shouldn't have to do it that way, also my neutral light does not come on when in neutral, any ideas what it could be? And what is the neutral switch could it be this if it is broken ? Thanks Link to comment Share on other sites More sharing options...
Moderator Airhead Posted September 9, 2013 Moderator Share Posted September 9, 2013 yes it sounds the likely cause Link to comment Share on other sites More sharing options...
YPVS TONE Posted September 10, 2013 Share Posted September 10, 2013 Check also the wire to the switch is not broken. if you disconnect the wire to the switch and earth it to the engine case the neutral light should come on. If it does then it does sound like the neutral switch. Link to comment Share on other sites More sharing options...
jackm20010 Posted September 10, 2013 Author Share Posted September 10, 2013 Ok thanks guys so basically take the neutral cable of from bike and put onto the engine casing and neatural should display? Link to comment Share on other sites More sharing options...
Moderator Airhead Posted September 10, 2013 Moderator Share Posted September 10, 2013 Ok thanks guys so basically take the neutral cable of from bike and put onto the engine casing and neatural should display? yes that is what Tony is saying, pick a clean unpainted part like a casing screw. Link to comment Share on other sites More sharing options...
Recommended Posts