insane-rp Posted April 9, 2013 Share Posted April 9, 2013 Hi. i have a 2001 dt 125 - first bike. i am new to bikes but have been a car mechanic for 10 years so playing with this a bit of fun as well as a learning process. the wiring on my bike has been cut about (to take basically all of the electrics off to make it into a motocross bike - by previous owner). it kicks over and starts / runs fine, however i have no operation of the power valve / servo. the power valve rotates and isnt siezed, cables are good, servo is in working order. therefore must be a wiring issue. i have a 3RM-20 cdi if that helps. and the ypvs servo is the five wire type, 4 in a connector and 1 with a bullet like connector. Looking for wiring diagrams for the bike to figure out why its not operating as it should. Any help would be much apreciated. Link to comment Share on other sites More sharing options...
Recommended Posts