cathunter Posted March 26, 2013 Share Posted March 26, 2013 hi iv got a dt 125 r 1996 im doing up for my girlfrend . I was told when i bought it that the 2 stroke oil pump maybe wasn't working. I put a new accelator cable on and did the test with pulley and that seems fine. The pump moves up and down. I checked the oil adjustment and thats fine. Is there any other way i can be sure that its taking 2 stroke in ? I am just paranoid that when it starts being used i will end up with a whole heap of problems if the 2 stroke is not going in ! Thanks for any help. Link to comment Share on other sites More sharing options...
Moderator Cynic Posted March 26, 2013 Moderator Share Posted March 26, 2013 Sounds fine. They are generally blamed for just about everything. You name it people blame the pump. In 25plus years of running 2 strokes i have never know one fail. It is a very basic plunger pump. Running in lubricant of all things. It should never pack up. Follow the manual and things should be golden. One tip i can give. Swap the black pipe on the 2 stroke system for clear on both feed and supply sides of the pump then you can see it working. Link to comment Share on other sites More sharing options...
cathunter Posted March 26, 2013 Author Share Posted March 26, 2013 cheers for the help the clear oil pipe is a good idea .thanks again Link to comment Share on other sites More sharing options...
YPVS TONE Posted March 26, 2013 Share Posted March 26, 2013 With the engine running, turn the pump pulley by hand to pump more oil and if you remove the oil pipe onto the carb you should see oil pumping out the end of the pipe. Obviously don't leave the pipe disconnected for more then a few seconds as you won't have oil going to the engine. Also worth making sure the system is bled ok. Make sure you have plenty of two stroke oil in the oil tank. With the engine stopped remove the small cross head screw on the side of the pump which usually has an orange washer under it and let the oil run out for a couple of minutes. Replace the screw and with engine running turn the pump pulley by hand to pump more oil to bleed the pipe from the pump to the carb. Link to comment Share on other sites More sharing options...
cathunter Posted March 26, 2013 Author Share Posted March 26, 2013 cool thanks alot for all your help i will get busy tomorrow .thanks again Link to comment Share on other sites More sharing options...
cathunter Posted March 27, 2013 Author Share Posted March 27, 2013 just put clear pipes on oil pump and it works a treat thanks for the help Link to comment Share on other sites More sharing options...
Moderator Cynic Posted March 27, 2013 Moderator Share Posted March 27, 2013 No problem. Appreciate the feedback too. Doesent happen very often. Glad its all sorted. Link to comment Share on other sites More sharing options...
Recommended Posts