ZR2G Posted July 4, 2005 Share Posted July 4, 2005 Hi All I did a very stupid thing. I have a DT125LC and the engine was redone, but the flywheel was pulled apart, meaning the magnets and the main center part came apart, STUDS removed at some stage in its life. What Iam needing to know is there a way to work this out again as I didnt mark it and now it has six holes which gives me 6 different ways to try, but is there a way to allign it without guessing?? On the flywheel is a number F3T251 and also a number 71 also another 2x11. The inside has 4 magnets On the round edge is a MARK "LINE" and on the face edge is a POP mark?? Any help PLEASE..??? Would it damage the engine if I were to try an inccorect position?? If anyone has a picture of a flywheel for this engine could you please email or post details.. Thanks Gary Link to comment Share on other sites More sharing options...
bikerguy210 Posted August 25, 2005 Share Posted August 25, 2005 having same problem did you sort it out if so could you help with advise or pics Link to comment Share on other sites More sharing options...
Admin Alex Posted August 30, 2005 Admin Share Posted August 30, 2005 Send mozzy a pm Link to comment Share on other sites More sharing options...
Recommended Posts