torence20 Posted October 5, 2012 Posted October 5, 2012 hey guys i have 2 75 dt 250 enduros im going to make one good bike from the 2 and with my second motor it will be going in a golf cart witch is almost done. my question to you is what wires do i need to hook up to get it to spark. i need the harness for the other bike so i dont want to hack it all up. this bike does not run a battery. thanks,
RogerD Posted October 5, 2012 Posted October 5, 2012 I think you'll need most of the harness if you want to use a key. At least the wiring to and from the rotor, the cdi, rectifier, coil and main switch - or a kill switch if you want to set it up that way Roger here's a basic wiring component photo.... http://www.cmsnl.com/yamaha-dt250b-19751976_model8548/partslist/F-05.html#results
Moderator Cynic Posted October 5, 2012 Moderator Posted October 5, 2012 An intro would help no end. People dont generally reply to 1st post questions...... Drop into the new members area and say hi.
Moderator Cynic Posted October 5, 2012 Moderator Posted October 5, 2012 I thought these bikes used points. Makes it a doddle to do.
blackhat250 Posted October 5, 2012 Posted October 5, 2012 Yip " Twinshock DT250"s are points, so too is the DT,MX,250f.[ early 1977] The DT400"s are cdi, , Welcome torence,,
dt502001 Posted October 5, 2012 Posted October 5, 2012 Just a suggestion as you have 1 harness make a copy of it. I take it you need to make 1 for the golf cart. So using a mulit meter set on ohms scale Identify each wire and simply make it longer.if you don't want the lighting/horn then omit them. You will need the ignition coil, charing coil /points, voltage regulator, kill switch. Geting a wiring diagram will make this easier.
Recommended Posts