Jump to content
This post is 4387 days old and we'd rather you create a new post instead of adding to this one. You can't reply in this post.

Recommended Posts

Posted

anyone ever had brake disks skimmed?

needing my project bikes brakes tidied up as there is plenty of life in them, rear not even been used, but due to sitting have became a wee bitty rusty

dont want to get the grit blasted cos it'll make a rought surface finish so was looking at getting them skimmed but have heard a few horror stories like disks warping ect

anyone got any advice/stories/experience ?

Matt

Do you want an ad-free experience? Join today and help support the Yamaha Owners Club.
  • Moderator
Posted

Sorry no dice. The official wear limit on those disks will be maybe 1mm.

If their marked or scored their fkd simple. You could maybe vapour bkast the carrier but even that my affect the bobbins.

At the end of the day they are a life or death item. Don't take chances.

  • 3 months later...
Posted

it would have been purely for cosmetic reasons, but i managed to clean them up with a wire wheel drill bit :)

Posted

They will just clean themselves when you use them, they will be ok after a few miles. Unless they are FUBAR.

  • Who's Online (See full list)

    • There are no registered users currently online
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...