busyeddie Posted July 3, 2012 Share Posted July 3, 2012 I have gearbox oil leaking from behind the flywheel I think? I cant be sure untl I get the flywheel off. Can this happen or is it more likely the sprocket seal or clutch? If it is the crank seal, how do I fix it?? I have heard it can be done in situ, but I have no idea how, any help much appreciated. Ed Link to comment Share on other sites More sharing options...
Moderator Airhead Posted July 3, 2012 Moderator Share Posted July 3, 2012 Gearbox oil cannot leak from the LH crank seal Ed, Its either the sprocket seal or the gearchange shaft seal, crank seal can be done in situ as can gearchange shaft seal but cant remember whether the sprocket seal can, maybe Cynic will know? Link to comment Share on other sites More sharing options...
Moderator Cynic Posted July 3, 2012 Moderator Share Posted July 3, 2012 Yes you can do it in situ, its the bearing you have to strip the gearbox for. Haven't done it myself mind, and i'd bet it will fight you as its a good size. Did mine when the cases were split. Its a dodle then. Link to comment Share on other sites More sharing options...
busyeddie Posted July 3, 2012 Author Share Posted July 3, 2012 Aah. Now im confused. Just had flywheel off, and it looks alot like the gearbox oil has been coming out of the crank seal. ie oil behind flywheel, and this area is pretty well secluded from the sprocket and gearchange because of the shape of the casting. Could the inner seal have gone too ? Link to comment Share on other sites More sharing options...
busyeddie Posted July 3, 2012 Author Share Posted July 3, 2012 Forgot to add, it only seems to leak when not running but warm. And having removed seal, its not a lip seal, its got a spring either side, which worrys me into thinking that some where inside is a lip seal where there should be a double seal? Eeek. Link to comment Share on other sites More sharing options...
Moderator Airhead Posted July 3, 2012 Moderator Share Posted July 3, 2012 it must be getting in the crankcase from the RH seal and exiting through the LH seal...ie both seals gone. I suppose it's rungin smokey and rough? Dont foget to buy the RH crank collar 'O' ring too Link to comment Share on other sites More sharing options...
busyeddie Posted July 3, 2012 Author Share Posted July 3, 2012 Damn, just placed order with yambits. Is it an engine strip job for rhs? It runs ok, maybe a bit Smokey, was running gear specific oil not engine oil though. Link to comment Share on other sites More sharing options...
Moderator Cynic Posted July 3, 2012 Moderator Share Posted July 3, 2012 Only the outer case and the primary drive gear, the gearbox side isn't so bad as it seals to a collar (with said 'o' ring inside) so relatively it should come out easier. Maybe remove the clutch basket for a bit more wiggle room. Don't mix the seals up when you get them they look very very similar. Link to comment Share on other sites More sharing options...
busyeddie Posted July 3, 2012 Author Share Posted July 3, 2012 They will be on separate orders so hopefully wont be mixing them up. So whip the case off, take the primary gear off, and.hopefully all good? Thanks lads, hope that fixes it! Link to comment Share on other sites More sharing options...
Recommended Posts