Rust Posted July 14, 2011 Posted July 14, 2011 Hello again , Im still picking at the bike here , and just finished painting the down tubes. I'd like to know the torque specs for the front wheel? There is one 7/8 Nut on one side where the pin goes through , and two 9/16 nuts on the opposite side. Should i use locktight? '79 xs400 right on , thanks.
Moderator drewpy Posted July 14, 2011 Moderator Posted July 14, 2011 Hello again , Im still picking at the bike here , and just finished painting the down tubes. I'd like to know the torque specs for the front wheel? There is one 7/8 Nut on one side where the pin goes through , and two 9/16 nuts on the opposite side. Should i use locktight? '79 xs400 right on , thanks. 72 ft lb for the big nut (no not you!) for the 13mm nut clamp; make sure the arrow under the clamp is facing forward, they are slightly sloped because you tighten the front one up first to 11 -18 lbsft then the rear which there should be a gap left. This acts like a spring keeping the axle and nut in place. I use aero nuts on mine but not really necessary drewps
Recommended Posts