Davieboy139 Posted April 15, 2011 Share Posted April 15, 2011 Evening all Im Dave, Ive just started a lil project on a DT 125 lc 89, fully restored bar the engine were i am having a world of trouble. I have in total 3 bottom ends and componets, but still out of all of this the one thing that is wrong with all of them is the gear selector spring is week. So here it is. I am after a complete gear selector shaft and end. Throttle twist grip and cable HT lead some good condition two finger handle bar leavers. Possible parts required to convert Dt125 to a Dt 175. Many thanks dave Link to comment Share on other sites More sharing options...
Moderator Airhead Posted April 18, 2011 Moderator Share Posted April 18, 2011 Greetings Dave, how about buying new parts, 'Yambits' will supply them mail order if they are available Link to comment Share on other sites More sharing options...
kishan Posted April 18, 2011 Share Posted April 18, 2011 welcome Link to comment Share on other sites More sharing options...
Davieboy139 Posted April 20, 2011 Author Share Posted April 20, 2011 tar thank for info is there any were u can get a wiring diagram for these bikes and possible ht leads? Link to comment Share on other sites More sharing options...
Moderator Airhead Posted April 20, 2011 Moderator Share Posted April 20, 2011 Haynes workshop manuals have wiring diagrams, as for HT leads they are an integral part of the ignition coil and are not supposed to be taken out and changed although it has been done before. More commonly if the internal thread is stripped at the plug cap end you may be able to cut off 20mm of the length and screw back into fresh lead? Link to comment Share on other sites More sharing options...
Moderator drewpy Posted April 20, 2011 Moderator Share Posted April 20, 2011 to the YOC forum Link to comment Share on other sites More sharing options...
Recommended Posts