Moderator Airhead Posted October 2, 2010 Moderator Posted October 2, 2010 gap is set right i dont know about timing though as i have no idea how to check or alter it Does your Haynes book not cover it?
webi Posted October 3, 2010 Author Posted October 3, 2010 Does your Haynes book not cover it? yes it does but i find it quite confusing
Moderator Airhead Posted October 3, 2010 Moderator Posted October 3, 2010 Turn the engine using the kickstart until the points are at the widest gap. Adjust this gap to the correct one in the haynes book. now set the engine to the correct place for the ignition (see your haynes manual) Place a cigarette paper between the points. loosen the screws holding the points backplate and turn the whole thing while pulling gently on the cigarette paper. You will find that at some position the points will begin to open and the paper will be free. Tighten the backplate screws in this position Job done Least thats what I used to do when i were a lad
Recommended Posts