wild foamy Posted September 12, 2010 Share Posted September 12, 2010 hi peeps i am now starting to remedy th elist of faults produced during my '89 XJ600s' MOT, the mudguard has now been secured with a custom bracket fabricated to hold it in place, fork seals have arrived, waiting to be changed. now the headstock bearings, they arent notchy but they need adjusting... how do i get to them to adjust them? i can see one of the nuts on the top of the headstock but i cannot get to the locknut which (i assume) is on top of it under a small plastic fairing between the handlebars which i cannot see a way of removing. help? -Steve Link to comment Share on other sites More sharing options...
wild foamy Posted September 12, 2010 Author Share Posted September 12, 2010 mods please delete... the problem has been remedied... how was i to know the cover came off to reveal a screw?... Link to comment Share on other sites More sharing options...
2 Wheels Posted September 12, 2010 Share Posted September 12, 2010 Well howdy Foamy !!! hows the army ? When tightening up the headstock bearing,,,,,,,tighten until it is tight then undo it by about 1/4 or maby 1/2 turn,,,,,check that the bars can turn freely in both directions without the need to push them arround with any force. Check them a few times before ya put everything back to geather. HTH. Link to comment Share on other sites More sharing options...
Recommended Posts