Dripping carb and cleaning plastic fenders

[saltcreekknife]

I just finished getting an 81 DT175 running. After it sat overnight, I noticed a little gas running out of the carb's overflow tube. (a 1" drip area on the floor, not much) I replaced the floatbowl needle. Could it be a faulty needle or do I need to check the floatbowl level?

Also, how do you clean the white plastic fenders. They are stained, and I do not want to damage the surface. Any thoughts?

Thanks

[chris66]

the leak could be float level but more likely your needle valve not seating tight, perhaps a little dirt.

i have always used a little t cut on white plastics.

[Airhead]

mine's dripping too, even with a new(ish) valve in it!

I had it out yesterday but it looked ok, I raised the float level from the recommended 21mm to 23mm...and it still leaks a bit. I will be getting a new valve next

Yeah try T Cut paint restorer or whatever you have on the East side of the Altlantic.

[drewpy]

for plastics I use Peeks polish, good stuff.

as far as needle valves, they are finiky buggers, I had to mess with mine right up to the day of the ride to Colraine from manchester.

[saltcreekknife]

I've not heard of the products you guys have mentioned. I will check around on the internet to see if they are available. If not, I will find something similar.

I will play around with the needle valve tomorrow and see what I can figure out

Thanks

[motobrox]

Try any UPVC window restorer on the plastics