Greetings people, got a bit of a problem, I can't recall how the chain tensioner goes together on my DT. Anybody do me a picture of one in situ so i can get mine on right.

I know it doesent fit in an obvious way but when you have it right its a dodle but i just cant see it.

Is this any use Cynic?

OHHH so close, any chance you could get a shot from underneath. Its the bloody spring that just wont sit right.

The manual, ha when i looked in it, there in black and white. "Its important to note she spring position when removing the tensioner"

My fault for not taking a photo, lesson learned.

i didn't take the pic, just did some googling last night when i couldn't sleep

I think the Thingy goes over the Yoke-a-me-joe, round the How-do-dode and then sits on the jim-bob.

Only messin mate !

SORRY Cynic me has no clue how it goes.

If i could help ya i would, good luck with it.

I think the Thingy goes over the Yoke-a-me-joe, round the How-do-dode and then sits on the jim-bob.

Only messin mate !

SORRY Cynic me has no clue how it goes.

If i could help ya i would, good luck with it.

Its alright i'll get it in the end, hopefully OG will be feeling charitable after his aircooled weekend.

got a picture of the tensioner intact off the bike, it may or may not help you

got a picture of the tensioner intact off the bike, it may or may not help you

Oh you are a star Vez, i can see where the spring locates on the arm. Watch this space.......

Ok now i feel stupid, (don't all shout at once) the chain tensioner spring and the rear brake return spring are vey similar. ie similar enough to mix up.

Stupid stupid stupid..........

No problem Cynic.   

I have to     Can't be helped