dragstar handlebar riser

[petercnm]

Hello all,

i just put a new handlebar on my dragstar. Now want to install risers where i can route the cables through...

Any idea's or suggestions? I see a lot of types available, but not sure about the rises with holes for the cables...do the holes go all the way through? Cannot figure that out looking at the pictures.

thanks a lot

[Ttaskmaster]

No idea, TBH...

Have you a link to the ones with cable routing?

[petercnm]

here's what i found.. http://cars-bikes.be/contents/en-uk/d2236_risers,risersets,stuurklemmen,stuurbevestiging,....html

sorry it's in dutch..

I think they didn't put up the right picture..i cannot see any holes.

thx

[petercnm]

just found these...looks good, but don't know if they'll fit my dragstar

http://www.cruisercustomizing.com/detail.cfm?Category_ID=62&manufacturer_ID=549&product_ID=28296&sblid_name=Biker_s_Choice_Detonator___Risers_____inch_Risers_with_Wire_Cover_for_Harley_Davidson_Sportster

[Ttaskmaster]

Right - Those will allow you to (fairly easily) run electrical wires down inside your bars and through the risers.

But NOT the control cables.

You can get completely internalised cables too - My colleague has them on his custom Victory.

However, this is very expensive and a "complete bitch to work on if something goes wrong".

I believe the Drags have 22mm diameter bars...

[petercnm]

Right - Those will allow you to (fairly easily) run electrical wires down inside your bars and through the risers.

But NOT the control cables.

You can get completely internalised cables too - My colleague has them on his custom Victory.

However, this is very expensive and a "complete bitch to work on if something goes wrong".

I believe the Drags have 22mm diameter bars...

[petercnm]

yes, the idea was to only route the electrical....the rest will have to wait till i find the money somewhere..