Jump to content

dragstar handlebar riser


petercnm
This post is 5494 days old and we'd rather you create a new post instead of adding to this one. You can't reply in this post.

Recommended Posts

Hello all,

i just put a new handlebar on my dragstar. Now want to install risers where i can route the cables through...

Any idea's or suggestions? I see a lot of types available, but not sure about the rises with holes for the cables...do the holes go all the way through? Cannot figure that out looking at the pictures.

thanks a lot

Link to comment
Share on other sites

Do you want an ad-free experience? Join today and help support the Yamaha Owners Club.

No idea, TBH...

Have you a link to the ones with cable routing?

Link to comment
Share on other sites

Right - Those will allow you to (fairly easily) run electrical wires down inside your bars and through the risers.

But NOT the control cables.

You can get completely internalised cables too - My colleague has them on his custom Victory.

However, this is very expensive and a "complete bitch to work on if something goes wrong".

I believe the Drags have 22mm diameter bars...

Link to comment
Share on other sites

Right - Those will allow you to (fairly easily) run electrical wires down inside your bars and through the risers.

But NOT the control cables.

You can get completely internalised cables too - My colleague has them on his custom Victory.

However, this is very expensive and a "complete bitch to work on if something goes wrong".

I believe the Drags have 22mm diameter bars...

Link to comment
Share on other sites

  • Who's Online (See full list)

    • There are no registered users currently online
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...