help i need to get a manual for an xvs 125(2000) the rear cam siezed and sheard the cam sprocket bolt i need to know how to set the rear cam up and set timing,but have been trying to get a service manual and have been told unobtainable by 1 dealer and back order available 2010 by another can any1 help please

Hard to find but weve had this before, your email? I will send you one

Hard to find but weve had this before, your email? I will send you one

Hard to find but weve had this before, your email? I will send you one

Hard to find but weve had this before, your email? I will send you one

hi thanks my email address is [email protected]. i have been searching for 1 of these for ages,but must disagree with you regarding the bloke who invented decorating as i work for a paint manufacturer.

sent it

for anyone else who wants one, try:

http://www.yamahaclub.com/forums/topic/13057-how-do-i-post-a-workshop-manual/page__hl__xvs125

I know it's an old thread but does anyone still have a link, or would be able to email one?

Got the owners manual but need the workshop or Haynes style one for xvs125. Thanks.

I have the full manual printed out into a large ring binder folder 

where abouts are you 

Bit of a trek I fear, down near Brighton.

I think I may have solved the problem now but thanks anyway, much appreciated.

Hi, I know this is but of an old thread but need some assistance.

My xvs 125 is lacking power and I suspect the pickup coil to be faulty or out of resistance, does anyone here knows what the reading should be when checking the pickup coil?  

 

Had to do a no-2 cylinder rebuild after the cam shaft driven gear rocked loose and came off.. after the rebuild it's not been right? But she has good compression, timing is spot-on, valve clearances seem good but will take measurements for those as well so I can reference to mine to be doubly sure.

 

If those two I've asked about match others readings/measurements then the only other thing I can think of it being us the ICU/ECU 

Can anyone offer any help on this? 

 

Thanks in advance!! 

Disconnect the pickup coil coupler from the harness

Red probe on the green/white

Black probe on the blue/yellow

Should read 192-288 ohms @ 20C