steptoe1111 Posted September 11, 2009 Share Posted September 11, 2009 hey guys how are you ihave a dt 175e i was just trying to find out how to redard the timeing to spec 1.8mmBTDC i under stand how to line the piston i can do that easyly i plan to use a flat piece of steel across the bore with the head removed and a feeler gauge, but what els is involved? when i did the crank seal on the left i lined the magneto base plate up with the two line marks on the uper right hand side and thought nothing more of it until i came across some thing i read in a forum recently, spinning the base plate is this how you alter the timeing if so is it just a case of lineing up the piston to spec then alinging the base plate up with the markers am i on the right track or not any help is allways apreciated thanks guys bye (yamaha owners club member "steptoe1111") Link to comment Share on other sites More sharing options...
Moderator Airhead Posted September 18, 2009 Moderator Share Posted September 18, 2009 , spinning the base plate is this how you alter the timeing if so is it just a case of lineing up the piston to spec then alinging the base plate up with the markers am i on the right track or not any help is allways apreciated thanks guys bye (yamaha owners club member "steptoe1111") Hi Shaun, quite an ingenious method of fixing the ignition poin there You are right about your assumptions too, see if the picture helps ...Paul Link to comment Share on other sites More sharing options...
Recommended Posts