Hi

My fz1-n on an 07 plate has cut out on me a couple of times, this happens when the bike is moving and in gear, when i pull over and restart the engine starts and runs perfectly.

this used to happen to my r6, i was told by yamaha that i needed a new throttle position sensor switch which they did for me but the r6 still kept cutting out.

any ideas.....

Could be a dodgy side stand switch, give it a good spray with WD40, check the connector etc.

Could be a dodgy side stand switch, give it a good spray with WD40, check the connector etc.

Many thanks for the help, bike has been running for over a week now...no cutting out...keeping my fingers crossed..

Hi

My fz1-n on an 07 plate has cut out on me a couple of times, this happens when the bike is moving and in gear, when i pull over and restart the engine starts and runs perfectly.

this used to happen to my r6, i was told by yamaha that i needed a new throttle position sensor switch which they did for me but the r6 still kept cutting out.

any ideas.....

Hi Ricardw,

I have the same 08 Fazeer and so for am unable to fault it, but will keep the side stand switch in

minds if it even cuts out, to date have done 6k on dunlop 211 that are not half worn and have good road holding

navi