adi750crow Posted March 21, 2009 Share Posted March 21, 2009 Can somebody out there suggest where i can get the torque settings ie; head,wheel nuts from for a 1971 YAS1. I have the clymer service manual which tells you all other info except these settings.Just the head nut settings would be usefull cheers ! Link to comment Share on other sites More sharing options...
JimR Posted March 21, 2009 Share Posted March 21, 2009 Can somebody out there suggest where i can get the torque settings ie; head,wheel nuts from for a 1971 YAS1. I have the clymer service manual which tells you all other info except these settings.Just the head nut settings would be usefull cheers ! Hi There, when the Yas1 was new no one worried about using a torque wrench to tighten stuff up, the wheel spindles were tightend up until the split pin hole lined up with the castle nut & the head(s) were just tightened down untill tight, but if you wish to be correct use data from a later manual (RD125a ~ DX) which will give you the sprocket carrier, wheel spindle and cylinder head torque settings, but I guess you dont need them too much Regards JIm Link to comment Share on other sites More sharing options...
adi750crow Posted March 21, 2009 Author Share Posted March 21, 2009 cheers for that jim. Link to comment Share on other sites More sharing options...
Recommended Posts