550dude Posted November 23, 2008 Share Posted November 23, 2008 I have a 1982 Seca 550 that will not start. I am currently trying to pull the timing plate off because it appears to be damaged. But as I turn a wrench on the integrated nut it also turns the crank. I put the bike in gear thinking that would stop it from rotating...no it did not. Cn someone help me on how to take the timing plate off of a 1982 Seca 550? Thank you. Link to comment Share on other sites More sharing options...
dsimon129 Posted November 23, 2008 Share Posted November 23, 2008 I have a 1982 Seca 550 that will not start. I am currently trying to pull the timing plate off because it appears to be damaged. But as I turn a wrench on the integrated nut it also turns the crank. I put the bike in gear thinking that would stop it from rotating...no it did not. Cn someone help me on how to take the timing plate off of a 1982 Seca 550? Thank you. New to the site. Just sayin' hi. Link to comment Share on other sites More sharing options...
Moderator YamaHead Posted November 24, 2008 Moderator Share Posted November 24, 2008 Sounds like you're gonna need a flywheel puller Easiest way to get @ that timing plate/pick-up coils......(*make sure scribe around the existing ones before you remove them)....makes it a whole lote easier when installing the new ones (if needed) Also mark the timing plate before removal as well. BTW..... to the forum Link to comment Share on other sites More sharing options...
grizzlydan Posted November 24, 2008 Share Posted November 24, 2008 Putting it in gear used to work for me. Although I always got a mate to stand on the back brake when doing so, helps to stop the engine turning over. Link to comment Share on other sites More sharing options...
Spraguepsycho1 Posted November 24, 2008 Share Posted November 24, 2008 If you can determine when both valves on a cylinder will be closed (piston comming up before or after compression stroke depending on direction of rotation) you can feed some rope down through the spark plug hole twisting it as you do to try to coil it on top of the piston. The main thing is to make sure both valves are closed so you don't bend one. Once that is done, as soon as the crank turns enough for the rope to contact the cylinder head, it should stop turning allowing you to pull the nut or bolt you were trying to remove. Just make sure you leave enough rope out of the hole to remove it once you're done and have backed the piston down away from the head releasing it. Hope this helps. Link to comment Share on other sites More sharing options...
Recommended Posts