psycho00 Posted August 11, 2008 Share Posted August 11, 2008 hello all. i have a poblem with my xt600 have him for 3 months and spend houres working on him. now the motor turns nice, but if i put him in 1st or 2 nd the motor stops running. even with the clutch held in. i found the killerswitch allready and bypassed it ( hope that will do ) i found out that the switch gave no contact when pulled out and broke the contact when was pushed in , so i shunted it anyone that had the same problem ??? Link to comment Share on other sites More sharing options...
fosdyke Posted August 11, 2008 Share Posted August 11, 2008 hello all. i have a poblem with my xt600 have him for 3 months and spend houres working on him. now the motor turns nice, but if i put him in 1st or 2 nd the motor stops running. even with the clutch held in. i found the killerswitch allready and bypassed it ( hope that will do ) i found out that the switch gave no contact when pulled out and broke the contact when was pushed in , so i shunted it anyone that had the same problem ??? Hi Is there a side stand switch? Check that this is working or bypass the switch. good luck Link to comment Share on other sites More sharing options...
Moderator Airhead Posted August 11, 2008 Moderator Share Posted August 11, 2008 Hi Is there a side stand switch? Check that this is working or bypass the switch. good luck Yep Link to comment Share on other sites More sharing options...
psycho00 Posted August 13, 2008 Author Share Posted August 13, 2008 Hi Is there a side stand switch? Check that this is working or bypass the switch. good luck hello fosdyke, yes there is a side stand switch i bypassed it by connecting the two ends of teh cable together but still the same result does somebody has a plan of the wires, than i can figure out where the problem is, i suppose that it is in thi sdirrection i should look Link to comment Share on other sites More sharing options...
psycho00 Posted August 13, 2008 Author Share Posted August 13, 2008 Yep hello oldgitonabike, yes there is a side stand switch i bypassed it by connecting the two ends of teh cable together but still the same result does somebody has a plan of the wires, than i can figure out where the problem is, i suppose that it is in thi sdirrection i should look Link to comment Share on other sites More sharing options...
Recommended Posts