Jump to content

Just discovered how to polish aluminium


Phil72
This post is 2993 days old and we'd rather you create a new post instead of adding to this one. You can't reply in this post.

Recommended Posts

Well as the title says, my dremel has been working overtime.

now have near mirror finish to my old stock clutch ' brake levers current ones chrome all flaked off,

'mirrors look awesome,

Been looking for reasonably priced accessories to replace some old plastic chrome parts that are damaged, anyone got recommendations as struggling to find parts.

Might struggle with these

B018809A-7D78-4C6E-9074-26C207C9B4F1_zps

thanks

Link to comment
Share on other sites

Do you want an ad-free experience? Join today and help support the Yamaha Owners Club.

I'd try fettling them corroded areas with the wirewheel/dremmel. Then try to match the paint up up, I recall hammerite do a very similar grey/silver in a small pot. Once dry, wipe them down with a acf50 rag.

If its chrome, buy a small tin of the spray chrome finish, spray a little into the lid, then brush it onto the areas reqd. Then same again, acf50 rag

Dont get it on the brakes or disc/s

Link to comment
Share on other sites

  • Moderator

its the laquer that had failed and corrosion has got underneath. would need to use wet and dry paper before polishing

  • Like 1
Link to comment
Share on other sites

Thanks for the advice, seen some YouTube clips on totally removing the lacquer and going bare metal polished. Like the sound of that lol

any ideas where I can get spares like the one below,

9E5423DF-D4A2-4397-B54A-7C8438781F74_zps

Link to comment
Share on other sites

Not familiar with this bike, but it looks like the part number is 5KS221100100 , but this is the entire rear arm - which I assume includes the plastic covering. (£600) As I have seen a few times with new OEM parts it may be hard to get this piece on its own. Might be worth looking on ebay or somewhere similar for used parts.

(Unless it is not an OEM part?)

Link to comment
Share on other sites

On 1/17/2016 at 0:07 PM, Phil72 said:

Well as the title says, my dremel has been working overtime.

'mirrors look awesome,

 

thanks

Yea, you can see your face in them  ;)

  • Like 3
Link to comment
Share on other sites

  • Moderator

you can get those plastikits and they will fill the ruts.

 

The stuff is really good as I have made brackets out of it

Link to comment
Share on other sites

3 hours ago, drewpy said:

you can get those plastikits and they will fill the ruts.

 

The stuff is really good as I have made brackets out of it

That would be cheaper than a new chrome part thanks

Link to comment
Share on other sites

  • Who's Online (See full list)

    • There are no registered users currently online
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...