rwd

Fitted a Peugeot Speedfighter lighting resistor works perfect

I didn't have a resistor that's why I needed to know the ohm / watts to be able to get one. Got it sorted now one from a Peugeot speedfighter works fine

YB100 Is it ok to have the 2 stroke tank outlet pipe lower / level with the 2stroke pump ? Is the pump craving feed ? Thanks

Could someone please tell me the Ohms & Watts for the resistor on my YB100. It's the one with a single black/yellow wire going to it. It should be near the rear light but isn't. Thanks

Sorted, broken wire in the loom under the tank

If I put a live from the battery to the brown wire on the front brake light switch everything works as it should. So there must be a break in this wire somewhere

Thanks will go and have a look. Give me anything mechanical bike car lorry engines gearboxes etc no problems electrics puzzle me

Got my YB100 sorted now the RXS has decided to play up. The problem I got is the horn - indicators & brake lights aren't working. the headlight - sidelight - rear light works. Tried a new battery but still nothing. Any ideas

Problem now solved running great

Where is the best place to get lighting / charge coil and Ignition source coil or complete stator for a 1985 Yamaha YB100

Hopefully may get a chance to have a look tomorrow.

Doesn't run, but have a spark

I have a blue spark, I havnt touched the stator plate, and set the point to what the manual says

Woodruff key is ok. Whats the best way to set the timing ? Ive done it the old fashion way ive always done piston at tdc and set it like that.

My YB100 wont start. When I got it it had been park in a garage since 2011 I cleaned the carb flushed the tank and it started and ran fine for about a week then decided not to start. I done a compression test and it was low so fitted new piston and rings and gaskets. The barrel looked ok. Still wouldn't start. Stripped and cleaned the carb again fitted new condenser - points - coil - plug - plug cap and done another compression test and its 100psi have a good spark. I put petrol down the plug hole and quess what ? Still wont start. Am I missing something that's staring me in the face ?